Differences

This shows you the differences between two versions of the page.

--- rundevicesdeploymentsasaservice [2022/09/22 22:38]
wikiadmin
+++ rundevicesdeploymentsasaservice [2022/09/22 22:40] (current)
wikiadmin
@@ Line 32: / Line 32: @@
 </code>
-<note important>Note: the default minimal configuration uses a %BASE% variable which could be defined instead of entering the full path to the application to run.</note>
+Note: the default minimal configuration uses a %BASE% variable which could be defined instead of entering the full path to the application to run.
 . Install the Service
@@ Line 42: / Line 42: @@
 </code>
-Note: Be sure that you do not have the GEMTool (or your project deployment) running before you start the service. You cannot have two deployments using the same port running at the same time.
+<note important>Note: Be sure that you do not have the GEMTool (or your project deployment) running before you start the service. You cannot have two deployments using the same port running at the same time.</note>
-. Check the service in the Windows services console. Open the Windows services console. You will see a GEMTool service listed. By default it is set to "Automatic" which means it will start when the computer starts.  You can start it by selecting "Start". It will then change to status "Running".
+. Open the Windows services console. You will see a GEMTool service listed. By default it is set to "Automatic" which means it will start when the computer starts.  You can start it by selecting "Start". It will then change to status "Running".
 You can stop/start/restart the service from this services console, or you can enter commands in the Windows command shell to do these functions. In the command shell you can also uninstall the service and stop or start it.