Differences

This shows you the differences between two versions of the page.

--- devices_runtime_configuration [2020/10/04 15:30] – created wikiadmin
+++ devices_runtime_configuration [2020/10/04 16:01] (current) – wikiadmin
@@ Line 18: / Line 18: @@
 {{:pasted:20201004-142944.png}}
+Each of the parameters is in a block that consists of the name of the parameter as a string and the value.  For example, the "passivePort" property looks like this:
 <code xml>
   <void method="put">
-    <string>activeConnectionRetryInterval</string>
+    <string>passivePort</string>
-    <double>-1.0</double>
+    <int>5010</int>
   </void>
 </code>
+You should not change any of the parameter names, but can change any of the values as needed for your application.
+**Important Parameters for Hosts and Tools**
+<file>
+  * deviceId - the device Id.  The host and tool must use the same device id
+  * baudRate - for SECSI tools, this is the serial port baud rate
+  * linkTestInterval - if greater than zero, TransSECS will periodically send an HSMS "linktest" messages.  This value is in seconds.
+</file>
+**Important Parameters for Tools**
+<file>
+  * passivePort - this is the port on which the tool will listen for connections from the host
+  * persistenceFileName - provide a filename for saving the GEM configuration.  This allows the configuration to persist over tool restarts.
+</file>
+**Important Parameters for Hosts**
+<file>
+  * equipmentHostName - the hostname or IP address of the tool
+  * activePort - the port on which the tool is listening for a connection.
+</file>
+**Timeout Parameters**
+Tool application will have these timeout parameters, as defined by the SECS standard.  Parameter units are as defined in the standard.:
+<file>
+  * passiveT1
+  * passiveT2
+  * passiveT3
+  * passiveT4
+  * passiveT5
+  * passiveT6
+  * passiveT7
+  * passiveT8
+ </file>
+Host applications will add the following timeouts, again as defined in the standard.
+<file>
+  * activeT1
+  * activeT2
+  * activeT3
+  * activeT4
+  * activeT5
+  * activeT6
+  * activeT7
+  * activeT8
+ </file>
+**Uncommon Parameters**
+<file>
+  * activeConnectionRetryInterval - for an "active" tool, TransSECS will periodically attempt a connection to the host. This value is in seconds.  (This is an unusual configuration and generally this parameter should not be changed).
+  * passivePort - Host applications.  This is used in host applications only when building a "pass through" or "Y-Tap" configuration. It should not usually be changed.
+</file>
+**Tech Support Parameters**
+Change these only if advised to do so by Tech Support.
+<file>
+  * allDeviceIdsValid
+  * allowDuplicateSECSIMessages
+</file>